Research

Quick Answer: Sump pump installation in Edmonton costs $2,000 to $3,000 for a standard residential setup. A proper install handles three Edmonton-specific challenges: clay subgrade that collapses without a properly lined pit, frost depth that freezes the discharge line solid, and winter power outages requiring battery backup to keep the basement dry. In This Article…

Quick Answer: Basement underpinning in Edmonton costs $300 to $600 per linear foot, or $45,000 to $120,000 for a full-perimeter residential project. It is reserved for severe settlement, structural failure, or basement lowering to gain headroom. APEGA engineering and City of Edmonton permits are required. Bench footing alternatives cost $30,000 to $80,000. In This Article…

Quick Answer: Basement waterproofing in Edmonton costs $2,000 to $40,000 depending on method. Interior crack injection starts at $1,500 per crack. Interior drainage systems run $8,000 to $20,000. Full exterior waterproofing with membrane and weeping tile replacement runs $15,000 to $40,000. Exterior is the engineered solution while interior is the practical retrofit. In This Article…

Quick Answer: Weeping tile is the perimeter drainage pipe around your foundation footing. In Edmonton, it clogs with clay fines over 25 to 40 years, leading to chronic basement leaks. Replacement costs $200 to $450 per linear foot exterior or $80 to $150 interior. Camera inspection confirms the failure before excavation begins. In This Article…

Quick Answer: Window well repair in Edmonton costs $400 to $2,500 depending on size, egress requirements, and drainage work. Most window well failures come from clogged drainage, missing covers, or frost-heaved subgrade. Alberta Building Code requires egress window wells for basement bedrooms. Poor window wells are a top-five Edmonton basement flood source. In This Article…

Quick Answer: Radon mitigation in Edmonton costs $1,500 to $3,500 for a standard sub-slab depressurization system. Alberta has Canada’s highest residential radon levels because of uranium-bearing bedrock under the province. A properly installed system cuts indoor radon by 80 to 95 percent within 24 hours and requires near-zero maintenance for 20 years. In This Article…

Quick Answer: Mudjacking in Edmonton costs $5 to $25 per square foot and lifts settled slabs to grade without demolition. Modern polyurethane foam has replaced traditional cement slurry for most Edmonton applications because it cures in minutes, is hydrophobic, and survives freeze-thaw cycles better. Driveways, garage floors, sidewalks, and patios all qualify. In This Article…

Quick Answer: Parging repair in Edmonton costs $3 to $8 per square foot, or $150 to $600 for a spot repair. When more than 30 percent of the surface is drumming, cracked, or spalling, a full replacement is the only lasting fix. Edmonton’s 91 annual freeze-thaw cycles destroy poorly installed parging fast. In This Article…